You can use the Line tool to draw individual lines or lines consisting of a number of connected sections.
To draw a line
Tip: When you draw connected line sections, it is advisable to activate the start symbol and to leave the end symbol inactive until you draw the last line section. This way, you can avoid duplicate symbols.
Tip: When you press and hold down the SHIFT key after you have placed the first point, additional points are created so that they are always orthogonal unless Enter at right angles or Enter using cursor snap is enabled in the dialog line.
Tip: You can use Back to undo the entries you make step by step.
Note: When you use the Line tool to draw a line consisting of several connected sections, every section is a separate entity that can be modified independently of the others. All the line sections you draw in one operation are given the same group number. Consequently, the line consisting of several connected sections is an entity group, which can be addressed and modified as a whole.
To draw lines consisting of a single entity, use the Polyline tool. For more information, see Drawing lines.
(C) Allplan GmbH | Privacy policy |