You can switch between Top and Bottom to select results for the top or bottom reinforcement layer.

You can switch between XSI and ETA to select results for the reinforcement direction.

You can switch between Tension and Compr. to select results for the reinforcement mode.

Use this to specify which additional boundary conditions the system is to take into account when it calculates the required reinforcement

This button is only available when the FEA document contains results for a half floor or when the document in question has been used as the basis for the calculation of punching shear reinforcement with the HALFEN-DEHA program.

Depending on the settings made for reinforcement layer, direction and content, the calculated reinforcement content is displayed. This includes information on the minimum and maximum reinforcement content.

If you activate this button (= Display On), the reinforcement contour lines are displayed. Otherwise they are not seen but are nevertheless available in the active document as data.