Position of placement and concrete cover

Tool(s): Place

Here you can specify specify the mark's location for the placement and set the parameters presented. Click OK to confirm the settings.

Location of mark

• Click Align (only available when Reinforce with 3D model is active) to adopt the basic orientation in space of the identified mark and to place the reinforcement in direct alignment.
• Click Move to use the selected view of the bending shape (when Reinforce with 3D model is not active ) or to use the basic spatial orientation (when Reinforce with 3D model is active) and to place the reinforcement along the placing line.
• Click Rotated to rotate the bars using the selected placing angle. In addition, you can use the X, P and Y buttons to align the bars so that they are perpendicular to the placing line, or to align them in the x and y direction.
  When Reinforce with 3D model is not active, the adopted view of the bending shape is rotated relative to the placing line.
  When Reinforce with 3D model is active, the adopted spatial orientation is rotated relative to the placing line.

Parameters for mark's location

Concrete cover all sides

Use this to set the same concrete cover for each side.

Concrete cover at start

Use this to set the concrete cover for the start only

Concrete cover at end

Use this to set the concrete cover for the bottom only

Concrete cover of placement

Use this to set the concrete cover for the side toward the placing line

Placing angle

Enter an angle here to rotate the bars using the selected placing angle. In addition, you can use the X, L and Y buttons to align the bars so that they are perpendicular to the placing line, or to align them in the x and y direction.
When Reinforce with 3D model is not active, the adopted view of the bending shape is rotated relative to the placing line.
When Reinforce with 3D model is active, the adopted spatial orientation is rotated relative to the placing line.