Parameters of placing region

Tool(s): Place Mesh Shape

When you create a placement along a placing line, you can define the following parameters.
When you have selected the Align option in the input options (you can only select this setting if Reinforce with 3D model is active and views already exist), the Relative to placing line option is not available as the basic spatial orientation of the identified mark is used and the reinforcement is placed in alignment. If this is the case, you can only define the concrete cover.

Relative to placing line

You can use the Left, Centered and Right settings to move the placement perpendicular to the placing line.

Same concrete cover

When you select this check box, the program applies the same concrete cover to all the edges. In this case, you only need to enter the concrete cover once.

If this check box is deactivated, you can enter separate values for the concrete covers at the start and at the end and for the concrete cover of the placement itself. You can see the position of each concrete cover in the graphics. There you can also click a bar and define the value.