Mark’s location for placing in rotation

Tool(s): Place in Rotation

Here you can specify the mark's location for the placement and set the parameters presented. Click OK to confirm the settings.

Location of mark

• Inside to place the reinforcement within the placing arc.
• Middle to place the reinforcement so that it is centered on the placing arc.
• Outside to place the reinforcement outside the placing arc.
• Align (only available when Reinforce with 3D model is active) to adopt the basic orientation in space of the identified mark and to place the reinforcement in direct alignment.

Parameters for mark's location

Concrete cover all sides

Use this to set the same concrete cover for each side.

Concrete cover at start

Use this to set the concrete cover for the start only

Concrete cover at end

Use this to set the concrete cover for the bottom only

Concrete cover of placement

Use this to set the concrete cover for the side toward the placing line