Sectional door SmartPart

You can define settings for the elements of the door on the Elements tab of the Sectional Door SmartPart.

Note: When you slowly move the cursor horizontally across the parameters, it changes to a double-headed arrow as soon as you reach the area between the parameter names and the boxes. Now you can change the width of this area.

Elements tab

Panels

Thickness: you can define the thickness of the panels by entering a value between 0.02 and 0.2 m.

Height of banding: you can define the height of banding; it must not exceed 2 cm.

Length of tongue/groove: the maximum value is 2 cm.

Number: you can define up to ten panels.

Type: you can specify the door type you want to create by choosing Paneled or Smooth.

Panels H / V: when you have selected the Paneled type, you can define the number of horizontal and vertical panels by entering a value between 1 and 10.

Opened by %: you can enter a percentage by which the door is open.

Hardware

You can enter the dimensions (1-8) for the hardware.
The meanings of the dimensions are illustrated in the graphics above.

Holder attached to ceiling: when you select this option, a ceiling-mounted holder for the rails is provided. To define the length of this holder, enter a value for the BL of ceiling.

Frame

Create: you can choose to create a frame.

Width / Depth: if you have selected the Create option, you can define the Width and Depth of the frame.

You can find information on the following tabs here:

You can find the following tools at the bottom of the palette:

Load favorite: you can retrieve SmartParts saved as favorite files (smv files).
Save as a favorite: you can save the current SmartPart as a favorite file (*.smv).
Info: displays the version number of this program, copyright and some legal notes. In addition, you can find a link to Allplan Connect.
Settings: you can open the Settings dialog box, where you can see and change the settings of the SmartPart.

Note: When you place or select a SmartPart, an arrow appears in the middle of the SmartPart. This arrow indicates the outside of the SmartPart. Depending on the position of the SmartPart within the opening, you can see another symbol This symbol indicates that the SmartPart is mirrored before it is placed. You can set the size and color of these symbols using the Size of CursorTips for snap points and Color of CursorTips options you can find in the Options (Default toolbar), Point snap page, Point snap representation area.