Palette: ToolsCreate area in the following module(s):
3D Modeling
Configuration: DesignBasic 3D Elements flyout
Click 3D Circle on the 3D Line Context toolbar.
To draw the circle, select one of the following options in the input options:
Circle based on center Define the circle based on the center point and radius.
Circle based on 2 points Define two points through which the circle is to pass.
Circle based on 2 points and radius/diameter. Click the points of the circle or the elements that are to be at a tangent to the circle. Overview of options for entering a circle
Enter a value between 16 and 144 for the Number of segments. This value applies to the current arc; it does not apply to the full circle.
Enter the start and end points of the arc. To draw a full circle, press ESC.
Tip: You can undo the entries you have made step by step by clicking Back in the Input Options.