Parameters for placing meshes

Reinforcement options

You obtain as realistic values as possible for the placement of groups of wire meshes using the parameters provided here.

Round-off value for mesh length/width

Enter the rounding value for the wire mesh size in longitudinal and transverse direction.

This way, you can prevent unusual mesh dimensions from arising when cut wire meshes are calculated.

Placement limit for excess mesh

Enter the threshold value for the size of mesh placements. This way, you can prevent meaningless mesh sizes from being generated.

A wire mesh is not placed when its calculated length/width minus the longitudinal/transverse overlap is smaller than the placement limit for excess wire mesh.

Example

Example for the excess mesh placement limit

Q524A l/b = 600/230 Overlap 50cm

When the excess mesh placement limit is set to 0.20m no residual mesh is placed for the missing 10cm.