Reference point for entering architectural elements

When you insert an opening in a wall, for example, or join an interior wall with an exterior wall, you need to click a wall. The point you click should be near to where the new element is to begin.

Note: If you want to proceed in this way, make sure that Enter offset directly on/off is switched off in the dialog line.

The distance to the nearest reference point (e.g., start of wall, wall corner, side of an opening) is presented in the dialog line.

The reference point is displayed as an arrow in the construction line color. The point you clicked (where the new element is to begin) is marked by a square in the construction line color. The tip of the arrow points to the point you clicked.

Tip: For precision drafting you do not need to click exactly where the new element is to begin. Just enter the precise value in the dialog line.


Fig.: entering architectural elements using reference points
A	Reference point; arrow points toward the new element’s origin
B	Start (origin) of new element; set by clicking on the wall
d	Distance to reference point – displayed in the dialog line

You can use the distance to the reference point as follows:

Accept the value in the dialog line by pressing ENTER.
Enter a new value in the dialog line and press ENTER to confirm.
To change the position of the reference point – because the distance to another corner on the wall is a known value – just click the other point. The new distance is displayed in the dialog line.

Note: Allplan always defaults to the nearest reference point.